Before the calibration - IR Connectivity Test

Before the actual Calibration, it is better (especially after a fresh install or reassembly) to run the IR Connectivity Test to make sure all sensors are connected in the proper order.

There are 2 parts to the IR Connectivity Test.  Run each test in the following order:

• Pillar Recognition: requires you to stand inside the scanner and tell the software which Pillar you see with lights turned on
• Connectivity Test: requires you to confirm each sensor is turned on.

While connected to the scanner's WIFI on your device, open the browser and go to https://calibkit.tg3ds.com:8443.  Log in and select "IR Connectivity Test." For iPhone users, use Safari for this operation and for Android users use Chrome. 

Pillar Recognition

Connectivity Test

A lit sensor

NOTE:  Read this article if some of the buttons on the user interface become unclickable